Telecaster Custom – Rebuild 1st update

I was out of the workshop all morning and had another small job to finish so didn’t manage as much as I would have liked.  However I made a start on the fret-board. The first, and probably most important step, make sure the fret-board is perfectly flat. With the neck flat I always mask up the fet-board […]

Merry Christmas

Merry Christmas to all out there in Guitar-land….. At least I managed to clear the bench for Christmas, so I don’t have any customers banging on my door, needing their instruments back for the holiday.  Now I can put my feet up for a rest. Speaking of Christmas though. If any of you should get anything […]

Another Gibson Fret Dress

They do make some classic guitars, I’ve got one or two on my wish list, but their quality control doesn’t seem to be so good these days!  This one wasn’t that bad but to get a really sweet setup I needed to level the frets……

Epiphone Acoustic Fret-Dress

This is a well loved guitar, it’s been well looked after but is starting to show some signs of wear now. The frets at the top of the neck in particular.  A fret-dress will even everything up nicely. Before I can level the frets I need to make sure the fretboard is level…. so a […]

Peavey Renovation – 1st Update

Got the body stripped down and cleaned.  Nothing too severe, just enough to remove the surface dirt. I’ve also cleaned off the rust from all the tremolo screws.  They all move freely now so I’ll be able to set the bridge height and intonation easily. I’ve stripped all the electrics from the pick-guard.  I’m going […]

Squire Stratocaster – Fret Dress

A nice colour,  in fact a nice guitar.  I was asked to just adjust the setup but what it really needs is a fret-dress. Rather worn frets… After a few hours, level frets. Once it’s back together it will play as well as any new guitar.  A lot better than when it was new, the frets […]

Fiesta Red Strat – Final Update

Another job done.  Looks and sounds great. I’ve included a small electrical mod I cam across recently, a resistor and capacitor in parallel across the live and output of the volume pot.  It ensures you retain the quality of tone when the volume is turned down rather than it all go a little dull. Only […]